Do not allow acid to come into contact with tissue or the eyes! Remove the hydrofluoric acid according to the manufacturer s instructions. Caution: Observe the manufacturer s warnings. Apply Calibra Silane Coupling Agent (sold separately, see complete Instructions for Use) only to surfaces that are required for adhesive cementation. Do not allow etchant into the screw channel. Apply 5% to 9% hydrofluoric acid etching gel (available separately, see complete Instructions for Use) to the bonding surface of the restoration only. Dry with clean, oil-free air.Ħ CEMENT 10 I 11 Clean, Etch, and Silanate Restoration Clean the restoration with an ultrasonic cleaner, steam cleaner or with alcohol, also clean the inside of the support of the TiBase. Clean the TiBase with alcohol, ultrasonic, or steam. Note: Do not sandblast the polished surface of the flange. Sandblast TiBase Sandblast only the surface of the TiBase intended for cementation (50 µm aluminum oxide, max 2.0 bar). Follow Instructions for Use for full firing options. Use caution when removing from furnace once complete. Select appropriate firing option for furnace and start the firing process. Fire Set restoration on approved firing pin or honeycomb and firing pad. Tip: Mark the correct position of the restoration to the TiBase using a pen. Ensure that the restoration can be fully seated onto the TiBase. Consult full Instructions for Use if stains are to be applied at the same time as glaze. Ensure all non-cementable surfaces are covered with glaze. Glaze Apply the glaze evenly across non-cementable surfaces. Cover the hex head of the abutment screw and fill the screw channel with easily removable material (e.g., soft wax, impression material, cotton or plumber s tape). Prepare the TiBase For better handling during the cementing process, it is recommended to attach the TiBase on the implant analogue or a polishing aid using screw. Observe the operating instructions for the materials used during the extraoral cementation process. 2.0 bar) and then cleaned (with alcohol, ultrasonic or steam). Only the surfaces of the TiBase intended for cementing to the restoration must be sandblasted (50 µm aluminum oxide, max. The contact surfaces of the TiBase to the implant should not be sandblasted or otherwise processed. General notes: The diameter of the TiBase must not be reduced, e.g., by grinding. Tip: Screw the TiBase into a lab analogue and use the screwdriver to protect the screw channel from glaze during application. 5 GLAZE FIRE CEMENT 08 I 09 Prepare for the Glaze Protect cement surfaces and screw channel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |